Skip to content
Cowboy's Air Conditioning & Heating (210) 495-7771
← All articles
Heating·7 min read·

What Does Aux Heat Mean? When It's Normal and When It's Not

If your thermostat says "aux heat," your heat pump is getting help from a backup heat source. A few minutes of aux heat is normal. Aux heat that runs for hours on a mild day is not. Here is what it means, when to expect it, and when it points to a problem.

Illustration: A heat pump outdoor unit
Aux heat: normal or not?

What aux heat means

"Aux" is short for auxiliary. On a heat pump system, aux heat is the backup heat that kicks in to help the heat pump. In most San Antonio homes with a heat pump, that backup is a set of electric heat strips inside the indoor air handler. In a dual-fuel system, the backup is a gas furnace instead.

The heat pump does most of the work. It moves heat from the outdoor air into your house. When it cannot keep up on its own, the thermostat turns on the backup heat at the same time, and shows "aux heat" or "auxiliary heat" on the screen.

You will only see aux heat on a heat pump system. A gas furnace or electric furnace by itself does not have an aux setting.

When aux heat is normal

Seeing aux heat for short stretches is part of how a heat pump works. These are the usual reasons:

  • You turned the temperature up by a few degrees. Many thermostats call for backup heat when the house is several degrees below the setting, so it warms up faster.
  • It is cold outside. A heat pump makes less heat as the outdoor temperature drops. On our colder nights, the backup heat may run along with it.
  • The heat pump is defrosting. In cold, damp weather, frost builds on the outdoor coil. The system runs a short defrost cycle, and the backup heat comes on so you do not feel cold air. See heat pump frozen in winter for what normal defrost looks like.
  • The house is warming back up after a night or workday setback.

In all of these cases, aux heat should shut off once the house reaches the set temperature or the defrost cycle ends.

Aux heat vs. emergency heat

They use the same backup heat, but they are not the same setting. Aux heat turns on by itself and works together with the heat pump. Emergency heat is a setting you choose. It shuts the heat pump off and runs only the backup heat. You would only use it if the outdoor unit is broken or iced over and you are waiting on a repair. We cover the difference in detail in EM heat vs. heat on your thermostat.

Why aux heat matters for your electric bill

A heat pump moves heat instead of making it, so it gets more heat out of each unit of electricity. Electric heat strips make heat the same way a toaster does. That works, but it takes much more electricity for the same amount of warmth.

So a little aux heat is fine. Aux heat that runs most of the day can make a winter bill jump, and it can also be a sign that the heat pump itself has stopped doing its job.

Signs aux heat is running too much

  • Aux heat stays on for hours when it is not very cold outside.
  • Aux heat comes on every time the heat runs, even with small temperature changes.
  • The outdoor unit is not running, or the fan is not spinning, while aux heat is on.
  • The outdoor unit stays covered in ice and does not clear.
  • The air from the vents feels warm only when aux heat is on, and cool when it is off.
  • Your electric bill went up sharply compared with a similar month.

Common causes when aux heat will not shut off

1. The heat pump is not running. A failed capacitor, contactor or outdoor fan motor can stop the outdoor unit. The backup heat then carries the whole load.

2. Low refrigerant. A leak leaves the heat pump weak, so it cannot reach the set temperature on its own.

3. A defrost problem. A bad defrost control or sensor can leave the coil iced up, or keep the system in defrost too long.

4. Thermostat setup or wiring. If the thermostat was installed or set up wrong, it may call for backup heat too early, or treat the heat strips as the main heat. A thermostat swap is a common time for this to start. See how to reset your thermostat.

5. Restricted airflow. A clogged filter or blocked returns make the system work harder and run longer.

6. Big temperature swings. Turning the thermostat up several degrees at once, or using deep setbacks, can bring on backup heat every time.

What you can check yourself

  1. Look at the outdoor unit while the heat is on. The fan should be spinning and you should hear the compressor running. If it is silent while aux heat is on, that is a repair call.
  2. Check the air filter and replace it if it is dirty.
  3. Keep the outdoor unit clear of leaves, plants and anything stacked against it.
  4. Raise the temperature in small steps of a degree or two instead of a big jump.
  5. Make sure the thermostat is set to "heat," not "emergency heat."

Do not pour hot water on an iced-over unit or chip at the ice. That can damage the coil.

Is it normal for a heat pump to run constantly in cold weather?

A heat pump runs longer cycles than a furnace. It puts out a steady stream of warm air instead of short blasts of hot air, so long run times are normal, and on the coldest nights it may run almost nonstop. That alone is not a problem as long as the house stays comfortable and the outdoor unit is running.

It is a problem if the heat pump runs nonstop on a mild day, cannot hold the set temperature, or leans on aux heat most of the time. Those are signs it needs service. See heater blowing cold air if the air from the vents also feels cool.

When to call for heat pump repair

Call a licensed technician if aux heat stays on for long stretches in mild weather, the outdoor unit is not running, ice will not clear, or your bill jumped and you cannot explain it. A technician can check the refrigerant charge, the defrost controls, the outdoor fan and compressor parts, and how the thermostat is set up to call for backup heat.

Cowboy's answers 24/7 with our own dispatch on Blanco Road. See heat pump repair in San Antonio, heating repair, or call (210) 495-7771.

Frequently asked questions

What does aux heat mean on a thermostat?

Aux, or auxiliary, heat is the backup heat on a heat pump system. It is usually electric heat strips in the indoor air handler, or a gas furnace in a dual-fuel system. The thermostat turns it on automatically when the heat pump needs help warming the house.

Is it bad if my aux heat is on?

Not by itself. Aux heat is normal for short periods, such as when you raise the temperature a few degrees, on cold nights, or while the heat pump defrosts. It is a problem if it runs for hours in mild weather, because that raises your electric bill and can mean the heat pump is not working.

Is aux heat the same as emergency heat?

No. Both use the same backup heat, but aux heat turns on automatically and works with the heat pump. Emergency heat is a setting you choose that turns the heat pump off and runs only the backup heat.

Why does my aux heat keep coming on?

Common reasons are big temperature changes at the thermostat, cold weather, defrost cycles, a dirty filter, low refrigerant, a heat pump that is not running, a defrost problem, or a thermostat that is set up or wired wrong.

Does aux heat use more electricity?

Yes. Electric heat strips use much more electricity to make the same amount of heat than a working heat pump does. A little aux heat is expected, but aux heat that runs most of the day will raise your bill.

Related service: heat pump repair in San Antonio · heating repair · all heating and cooling services. Cowboy's AC answers 24/7 at (210) 495-7771.

Cowboy's Air Conditioning & Heating · 6510 Blanco RdSan Antonio, TX

Keep reading.

All articles →
Illustration: A heat pump outdoor unit
Heating · 5 min

EM Heat vs. Heat on Your Thermostat

Illustration: The seasonal checklist
Heating · 5 min

Heat Pump Frozen in Winter? What to Do

Illustration: A repair, measured not guessed
Heating · 4 min

Heater Blowing Cold Air? Causes & Fixes

Call now Callback